Maurizio
www.nipeservice.com
www.nipeservice.com
Wonderful!
EMG
FiveTech Support Forums
FiveWin / Harbour / xBase community
Board index FiveWin for Harbour/xHarbour Calendar / Appointment
Page: 1 2 (19 posts)
Richard,
No, not at the moment, it´s a project still in progress. At first it was planned to be commercial product, but my actual work in our university as a teacher of CAD takes much time. At the moment I have not much time for programming.
But I will think about it.
Richard Chidiak wrote:Stefan
Can you share the source code of the class ?
Richard
No, not at the moment, it´s a project still in progress. At first it was planned to be commercial product, but my actual work in our university as a teacher of CAD takes much time. At the moment I have not much time for programming.
But I will think about it.
kind regards
Stefan
Stefan
Maurizio wrote:Hello
I have almost finish this control .
Regards MAurizio
www.nipeservice.com
NON HO PAROLE !!!!!!
Accidenti a me quando ti ho inviato la mia classe !!!
Best Regards, Saludos
Falconi Silvio
Falconi Silvio
Page: 1 2 (19 posts)